|
|||||||
| Guitar, Amp and Pedal Mods/Repair Section for all the tinkers and people looking for technical help. Guitar Tweaking, Amp Mods, and Pedal Setups are in discussion. REMEMBER Music Toyz.com has no responsibility for content. |
 |
|
|
Thread Tools | Display Modes |
|
#1
01-24-2010, 12:36 PM
|
|||
|
|||
phase 90 mod fail??
ok, so i tried the r28 mod on my 2009 phase 90 (red circuit board), so i desoldered the resistor and now the pedal wont work...it works fine when its in the off position, but when i click it on the only thing that happens is that the battery gets very hot (suggestion a short) but i cant figure it out...any help would be great...thanks
shy 
|
|
#2
01-25-2010, 03:27 AM
|
|||
|
|||
|
Hey, can you snap us a pic of your work?
Is the 24k resistor now in series with the pcboard? If the battery is getting hot, sounds like there may be a solder bridge (short across the power line) or a component on the board got stomped in the process and now is a direct short to ground.
__________________
ampdoc myspace.com/akgservice
|
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
